1. ____ combustion is combustion that occurs when fuel is
burned using only the theoretical amount of air?
A. Perfect
B. Incomplete
C. Complete
2.
What is the highest pressure in pounds per square inch at which a boiler can be
safely be operated?
A. NOWL
B. MAWP
C. ASME
D. LWEC
3. When using excessive cold water makeup on a boiler system the water must be
_____ to increase effciency?
A. Filtered
B. Vented
C. Heated
D. Recirculated
4. Thermodynamic steam trap
opens and closes by?
A. Float
B. Sensor
C. Movable Disc
D. Bellows
5. If water is comes out of the top
try cock, what action should be taken?
A. Stop the boiler
B. Shut off the
fuel
C. Carefully blow down the boiler
D. Start the feed water pump
6. Who would typically oversee the repairs to a boiler system?
A. EPA
B.
OSHA
C. Local Boiler Pressure Vessel Code Officials
D. Fire Board
7. A low water cutoff does what?
A. Shuts the burner
down
B. Increases steam pressure control
C. Adds water
D. Purges non
condensibles out of the boiler
8. Boilers are
chemically treated for what reason?
A. Prevent over pressure
B. Prevent low pressure
C. Prevent formation of scale
D. None of the above
9. Condensate build up in steam lines causing what?
A.
This is normal and causes no problems
B. Water hammer
C. Foaming
D. Loss of efficiency
10. A cause
of steam not flowing may be?
A. Strainer clogged
B. Thermostat element in
float trap not functioning
C. End of the steam main trap broken
D. All of the above
Contact: Hvaclicense.com
Back to: Hvaclicense.Com
main page